See picture,this is Open-loop to Closed-loop Conversion oscilloscope waveform,my motor startup failure at this moment. I need some advice how to optimize this waveform,Make this electromagnetic Angle ...

Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask ...

Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask ...

Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC ...

I have a problem with running my CLA CODE when I run my program in flash. When i run thise program in RAM, i don't have these problems. Problem description: CLA TASK1 is triggered by int 6.11 (SD1).

Texas Instruments (TI) Audio support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search audio IC content or ask ...

Please go through attached schematic in which LM5109BMA/NOPB is used as gate driver for Three-Phase bridge.IRF530PBF is used as MOSFET Switch. -> We have 10V power supply with current capability of ...

Texas Instruments (TI) MSP low-power microcontrollers support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search MSP low ...

Texas Instruments (TI) Amplifiers support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search amplifier IC content or ask ...

Texas Instruments (TI) Sensors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search sensors IC content or ask ...

I understand from the Sys/Bios download page that ver. 6.83 supports CCSv10.1.0 or higher. Our customer would like to know how to create a Sys/Bios project in CCS ver. 12. Are the training videos in ...

I would like to know if there is an example for configuring GPIO interrupt using SYS/BIOS. The generic example uses PIE Vector tables and I guess it should not be used while using SYS/BIOS.